Table of Contents
Advertisement
Figure 4-14: Ethernet connection – XIO / RMC (daisy chain topology)
Legend: Ethernet connection (daisy chain topology)
ID
Name
1
Host System with PCCU
2
TCP/IP network
4.6.2
Configuration overview
The configuration procedures assume the following:
–
The XIO has its factory default configuration. This configuration combines all Ethernet ports into a
single 4-port switch configuration.
–
A single valid IP address will be assigned to the XIO. This IP address is unique in the field network
and replaces the factory default.
–
The Totalflow remote controller is the RMC-100 which is configured as a 2-port switch and already
has a unique and valid IP address compatible with that of the XIO (same subnet).
IMPORTANT NOTE: TCP/IP based communication can take place between a Totalflow controller and
an XIO when both have their factory default IP addresses intact. However, it is best practice to use
unique IP addresses even if only one XIO is installed.
All XIOs have the same factory IP address. Installations with multiple XIOs must replace the default IP
address with a unique address for each device.
To configure the XIO for network communication, follow the applicable procedures:
–
If the XIO connects to a third-party controller, follow steps in section
then,
4.8 Configure Ethernet-Serial
beyond the scope of this manual. Consult the vendor documentation.
46 | XIO USER MANUAL | 2106424MNAA
ID
Name
3
RMC (Ethernet ports configured in 1-Network Mode)
4
XIO
Passthrough. The configuration of a third-party controller is
4.6.3 Configure the XIO
and
Hide quick links:
Advertisement
Table of Contents
