Security Switch - ABB XIO-08 User Manual

Figure 2-10: External power mode
Legend: External power mode
ID Description
1 External power supply
2 External power terminal connector
3 XIO device
IMPORTANT NOTE: If you do not use ABB-approved power sources, verify that the customer-
supplied power source meets these requirements. For additional details about requirements, see
section 3.1 Site planning and
2.2.4

Security switch

The XIO has a security switch located between the Wireless Antenna Connector and the System Status
LEDs (Figure 2-11).
DANGER – Serious damage to health / risk to life. Explosion Hazard: The security switch
cannot be changed unless the area is known to be non-hazardous.
When the security switch is in the ON position, PCCU requires security codes to connect with the device.
For more security information, see section
requirements.
8 Configure security
XIO USER MANUAL | 2106424MNAA | 21
(recommended).