Enable Front/Back Panel Usb Device; Wake-Up Function(Jusb/Jfusb); Lan Switch(Jlan) - QDI P2S Manual

Installation Instructions
Enable Front/Back Panel USB Device Wake-up Function (JFUSB/JUSB)
The mainboard provides the advanced USB device wake-up function. The system can
be waked up from its power saving status including ACPI S3 by activating USB device.
Before using this function, set JFUSB/JUSB with pin1 & pin2 closed. Otherwise, set
JFUSB/JUSB with pin2 & pin3 closed for disabling. Furthermore, the item "Wake-Up
From S3 by USB"in CMOS Setup should also be set correspondingly to enable or
disable this function.
LAN Switch ( JLAN )
(Available on P2S-L)
If you want to use LAN, set JLAN to the normal status with pin2 & pin3 connected.
δÃüÃû-2
JUSB
JFUSB
Manual for P2S series
22
3
1
3 2
2
Disable
1
JFUSB JUSB
Enable
3
3
2
2
(default)
1
JFUSB JUSB
1 2
3
Disable LAN
JLAN
1
2 3
Enable LAN
JLAN
( default )
02-2-19, 10:59
1