QDI P2S Manual page 54

RecoveryEasy
b. If choosing to install RecoveryEasy on an absolutely clear disk, the utility will
delete all the previous partitions.
c. The password is set as default setting "qdiqdi" after installing RecoveryEasy.
1.2 CREATE PAR
Function : Creates a new partition.
Limitation : When no disk space remains or 4 partitions already exist, this
button is disabled.
Steps : After pressing the "CREATE PAR" button.
a. The system will prompt whether users want to create a mirror partition for it or
not.
b. If answering "Y", input the new partition size in Megabyte. Notice that the
maximum partition size that can be assigned is half of the left disk space, which
is also displayed in the status line. Another half is for the mirror partition. If
answering "N", the whole disk space left can be assigned. See figure-2.
Note:
a. The system will prompt "Insert system floppy, then reset" when the first
partition on the first hard disk is created.
b. After using DOS6.xx boot disk to format C partition, the system should be reset
in order to access the partition.
c. In Windows system 1,048,576 bytes equal 1 Megabyte, while in RecoveryEasy
1,000,000 bytes equal 1 Megabyte, therefore a smaller size will be displayed in
Windows system compared with the size displayed in RecoveryEasy.
1.3 DELETE PAR
Function : Deletes the last partition and its mirror partition.
Limitation : When no partition exists, this button is disabled.
Steps : After choosing this function, only the final partition can be deleted
in order to keep the continuous disk space. If the warning message
is confirmed, the partition will be deleted. By pressing "N" or "ESC"
key, the system quits.
δÃüÃû-2
figure-2 Create Partition
Manual for P2S series
54 02-2-19, 11:00