QDI P2S Manual page 38

BIOS Description
Suspend Type
l
l MODEM Use
IRQ
l Suspend Mode
l HDD Power
Down
l Soft-Off by
PWR-BTTN
CPU THRM-
l
Throttling
l Wake-Up by PCI
card
l Wake-Up by
Ring/LAN
l Resume
by Alarm
l Primary IDE 0/1,
Secondary IDE 0/1 Disabled
δÃüÃû-2
Stop Grant Select the Suspend type.
PwrOn Suspend
3,4,5,7,9, Special Wake-up event for Modem.
10,11
NA This function is not applied.
Disabled The system never enter Suspend mode by timer.
1Min ~ 1Hour Define the continuous idle time before the system
enters Suspend mode. If any items defined in
"PM Events" are on and activated, the system will
be woken up.
Disabled HDD's motor will not be off by timer.
1 - 15 Min Define the continuous HDD idle time before the
HDD enters power saving mode (motor off).
Instant-Off The system will immediately power off once the
power button is pressed.
Delay 4 sec The system will power off when power button is
pressed for 4 seconds.
12.5%, 25%, Select the duty cycle of the STPCLK# signal,
50%, 37.5%, slowing down the CPU speed when the system
62.5%, 75%, enters green mode.
87.5%
Enabled Allow the system to be waked up by PCI card.
Disabled Do not allow the system to be powered on by
PCI card.
Enabled Allow the system to be powered on when a
Ring indicator signal comes up to UART1 or
UART2 from external modem (to LAN Wake-up
Header from LAN adapter or to modem Ring on
Header from internal modem card).
Disabled Do not allow Ring/LAN wake up.
Enabled RTC alarm can be used to generate a wake-up
event to power up the system.
30Disabled RTC has no alarm function.
Enabled Reload global timer, when there's an IDE event.
Do not reload global timer.
Manual for P2S series
38 02-2-19, 11:00