Clear Cmos(Jcc); Enable Usb Keydevice Wake-Up Function(Jusb1, Jusb2); Ac97&Mc97 Selection(Jmc1, Jmc2, Jac1) - QDI ADVANCE 10F User Manual

Clear CMOS (JCC)
If you want to clear CMOS, unplug the AC power supply first, close JCC (pin1 & pin2) once,
set JCC back to the normal status with pin2 & pin3 connected, then power on the system.
Enable USB KeyDevice Wake-up Function (JUSB1, JUSB2)
The mainboard provides the advanced USB keyDevice wake-up function. The system can
be waken up from its power saving status including ACPI S3 by activating USB keyDevice.
When using this function, set JUSB1&JUSB2 with pin1 & pin2 closed. Otherwise, set
JUSB1&JUSB2 with pin2 & pin3 closed for disabling.
JUSB2
AC97&MC97 Selection (JMC1, JMC2, JAC1)
Advance 10B/Advance 10F mainboard is compatible with AC97 and MC97specification.
Refer to the table for information on how to set them.
Note, For Advance 10F without AC'97 codec, the jumpers JAC1, JMC2, JMC1(1-
2), JMC1(3-4) are shorted to support AMR device.
Normal status:
1
1
Clear CMOS:
(Unplug the AC power supply)
1
Disable:
2
JUSB1
3
JUSB1
1
Enable:
2
3
JUSB1
JAC1 JMC2
JMC1
Jumper Function
AC97 Only
AC97+MC97
'1-2' represents pin1 &pin2 closed.
'3-4' represents pin3 & pin4 closed.
chapter 2
JCC
JCC
1 2 3
JUSB2
1 2 3
JUSB2
JMC1 JMC2
1-2 Close
1-2, 3-4 Open
2 3