QDI P2S Manual page 26

Installation Instructions
Furthermore in order to implement this function, set "POWER ON Function" to "Pass-
word" and enter the keyboard power-on password in the "INTEGRATED PERIPHER-
ALS" section of the CMOS SETUP. Save and exit, then power off your system. In this
case, the power button's power-on function is disabled.
Note:
1. If using this function, 5VSB line of the power supply should be capable of
delivering enough current for all the devices connected to the keyboard
port, if not, you will be unable to power up the system using the keyboard.
2. If you set JKB with pin2 & pin3 closed, set "POWER ON Function" to BUT-
TON ONLY, don't set it to Password, or you'll be unable to power up your
system by the keyboard or the power button.
3. If you encounter the above problems, clear CMOS and set the jumper pin2
and pin3 closed to disable the function,them power on the system by pushing
the power button,and set "power on Fuction" back to "Button Only".
Manual for P2S series
26 02-2-19, 11:00
δÃüÃû-2