Speaker Connector (Speaker); Power Led Connector (Pwr_Led); Green Led Connector (Green_Led); Acpi Led Connector (Acpi_Led) - QDI P2S Manual

Installation Instructions

Speaker Connector (SPEAKER)

The connector can be connected to the speaker on the case.

Power LED Connector (PWR_LED)

When the system is in S0 status, the LED is on. When the system is in S1 status, the
LED is blink; When the system is in S3,S4, S5 status, the LED is off. The connector has
an orientation.

GREEN LED Connector (GREEN_LED)

When the system is in S0,S1,S4 ,S5 status, the LED is off,When the system is in S3
status, the LED is on.

ACPI LED Connector (ACPI_LED)

The ACPI LED is a dual-color light with three pins. Pin1and Pin2 drive different color
lights. If Pin1 drives the orange light , then, Pin2 drives the green light, the following
status will come out. When the system is in S0 status, the LED is green on. When the
system is in S1 status, the LED is green blink. When the system is in S3 status, the
LED is orange on. When the system is in S4, S5 status, the LED is off.

Hardware Green Connector (SLEEP SW)

Push once the switch connected to this header, the system enters suspend mode.

Key Lock Connector (KEYLK)

The connector can be connected to the keyboard lock switch on the case for locking
the keyboard.
δÃüÃû-2
HD_LED
Manual for P2S series
14
HDD LED(+) HDD LED(-)
VCC
ORANGE(-)
GREEN(-) GND
LED+ NC
POWER SPKDATA
GND RESET
EMPTY GND
EMPTY EMPTY
LED+
SLEEP
GND LED-
LED-
LED+
GND
LED-
LED- KEYLOCK
02-2-19, 10:59