Ricoh MP C6502SP Field Service Manual page 295

3. Loosen the screws ( x4) of the joint bracket attached to the upstream unit.
4. Insert a spacer and tighten the screws.
If the trailing edge of the paper is skewing toward the front of the machine, insert a spacer [A]
under the rear end of the bracket and tighten the screws.
-or-
If the trailing edge is skewing toward the rear of the machine, insert a spacer [B] under the front
end of the bracket and tighten the screws.
5. Do another run to check the adjustment. If skew is still present, insert another spacer.
• Each spacer is 2 mm thick.
• Only two spacers are provided, so the maximum adjustment is 4 mm (using two spacers).
Multi-Folding Unit FD4000 (D615)
293