Auxiliary Trays - Ricoh MP C6502SP Field Service Manual

21. Check the finisher operation.
22. Print out five A3 or DLT sheets to the proof tray and check the side-to-side registration as follows:
A3 sheets: Use the scale marks on the FRONT exit roller [B].
• If the paper edge lines up with the center marking [D], the paper is aligned correctly.
• If the paper edge is aligned with marks to the right of center, the paper is shifted toward the
front (operator) side.
• If the paper edge is aligned with marks to the left of center, the paper is shifted toward the
rear (non-operator) side.
DLT sheets: Use the scale marks on the REAR exit roller [A].
Check the side-to-side registration in the same way, using the rear rollers.
23. If side-to-side registration is shifted, see page 1368 "Adjustment 009: Staple misalignment (3 mm or
more) occurs" and correct the shift.
[A]: Scale marks for DLT
[B]: Scale marks for A3
[C]: 7 scale marks in 2mm intervals
[D]: Center mark
24. Print out some sheets with center-folding and make sure that the folding line is not misaligned or
shifted.
• If the folding line is misaligned or shifted, see the Troubleshooting section and make
adjustments. (See page 1529 "How to improve center-folding accuracy (SR4100)")

Auxiliary Trays

Make sure that the customer understands the following points about these auxiliary trays:
Finisher SR4090 (D703) /Booklet Finisher SR4100 (D704)
153