4. Replace the above five parts
5. Run SP2-696-001 (Force Apply Lubricant Execute) manually
OPC Drum
1. Charge roller unit (
2. Drum cleaning unit (
3. To remove the drum [A], move it to the front side (to the left as shown above), then pull it out from
the rear side (the right side as shown above).
• After removing the OPC drum, place it on a clean, flat surface.
Attaching the New OPC Drum
1. When replacing, apply the lubricant powder (D0159501) (zinc stearate) evenly with a brush to
the OPC drum.
page 683)
page 684)
PCDU
689