D135/D136 - Ricoh MP C6502SP Field Service Manual

D135/D136

1. Turn off the main power switch, and then unplug the power cable from the main machine.
2. Close all the doors and trays that are openable and closable, and then secure them in place with
shipping tape.
3. Make sure to follow all the precautions listed below when moving the machine. This is to prevent
the machine from being damaged and the drawer unit from coming out.
• Do not put a load on the ADF
• When moving the machine, push the machine instead of pulling the machine. Pulling the
machine may cause damage of the covers.
• When pushing the machine, push the upper side of the machine in the areas marked with red
rectangles below. If you move the machine over an uneven surface, insert your hands under
the machine at the places marked with red rectangles below, and then lift the machine slightly
to get over the uneven surface.
• When you move the machine, face the left or right side of the machine toward the direction of
movement. Then, push the machine forward at a slow walking speed. Go slower if there are
any uneven areas on the floor.
• However, if you cannot face the left or right side forward, move the machine with the front
side facing forward (in the direction you are moving).
• Do not face the rear side of machine toward the direction of movement. This is because if the
floor is inclined upward, the trays and drawer unit may come out.
• Do not push or lift the location marked with red rectangles below. You may damage the
machine.
Main Machine Installation
143