Assembling The Omnivac Secretion Aspiration System - Weinmann Module System Instructions For Use Manual

Parts
Mask for inhalation,
reusable
CPAP valve
11.3 Assembling the OMNIVAC
secretion aspiration system
Clean
In hot water with
a mild household
detergent
Disposable item, re-use not permitted, replace for every patient
(1) After disinfecting the parts, rinse them thoroughly in
distilled water and then leave them to dry.
(2) Hot steam sterilization at 134 °C in devices to EN 285,
dwell time 5 minutes.
Following the hygiene treatment, reassemble the
parts in reverse sequence (see "11.1 Preparing the
OMNIVAC secretion aspiration system" on
page 39).
Disinfect
machine cycle
Immerse in
Washing cycle
dilute solution
up to 95 °C
(1)
Hygiene treatment
Washing
Sterilize
Hot-steam
sterilization
up to 134 °C
(2)
EN
41