Stop Aspiration - Weinmann Module System Instructions For Use Manual

Important!
Important!

10.3 Stop aspiration

38
EN OMNIVAC secretion aspiration system
Emptying the aspirate bottle
When the aspirate bottle is full to the limit, you must
interrupt the aspiration process and empty the
aspirate bottle.
When taking off and emptying the aspirate bottle,
please ensure that the lid does not accidentally come
off the bottle and cause the contents to spill.
1. Take off the vacuum tube.
2. Take the aspirate bottle out of the bracket.
3. Carefully take off the lid of the aspirate bottle.
4. Empty the aspirate bottle.
Comply with the relevant regulations on disposal
(see "3.1 Safety instructions" on page 8).
5. Push the aspirate bottle lid back on.
6. Put the aspirate bottle back into the bracket.
7. Reconnect the vacuum tube.
8. You can now continue aspirating.
When the aspiration process is complete, proceed as
follows.
1. Switch off the vacuum source.
2. Empty the aspirate bottle (see "Emptying the
aspirate bottle" on page 38).
3. Clean the OMNIVAC (see "11. Hygiene
treatment" on page 39).