Advanced Cli Configuration; Restart; Help; Firmware Update - ATTO Technology iPBridge 2600 Installation And Operation Manual

• Enable/disable Identify Bridge
Refer to Maintenance commands
details on each parameter.

Firmware update

Updates firmware using ExpressNAV. Refer to
Updating firmware on page 17.

Advanced CLI configuration

Allows you to input any CLI command available
through the iPBridge. See Exhibit 6.1-1 for an
example. Refer to CLI provides ASCII-based
interface on page 31 for information about CLI.
1 Type in the CLI command
2 Click the Submit button.
A text field beneath the box lists the most recent
commands issued to the iPBridge through this
page.
If you enter an incorrect parameter, the CLI
help text is displayed, showing the parameters
available.
3 If your entry was correct, type
saveconfiguration
4 Click the Submit button. Your changes are
implemented.
Exhibit 6.1-1 Command and response sequence in the CLI Advanced Configuration page.
Ready prompt
Command input
Error message
Help text
Correct input
Response

Restart

on page 43 for
Implements a firmware restart of the bridge and makes
permanent any changes you have made since the last
firmware restart.
1
2

Help

Gives help information about the command line
interface commands and troubleshooting tips via links
to pages with help text for each category of options
and one link to the Troubleshooting Tips and FAQs
page on the ATTO website,
from the CD included with your iPBridge.
Contact information for ATTO technical support is on
the right.
Help is always available by pressing any word shown
in red on the screen
Click the Restart button.
A box tells you to wait until the counter gets to
0 and then the browser refreshes.
If the browser does not refresh after the counter
gets to 0, click the link to refresh it manually.
Note
Restarting the firmware may take a few
minutes.
www.attotech.com
, or
28
Browser-based GUI