ATTO Technology iPBridge 2600 Installation And Operation Manual page 56

These commands configure the management and data Ethernet ports including TCP/IP parameters.
DPMTU
Controls the MTU (Maximum Transmission Unit) used by
the Ethernet ports: Increasing the MTU may improve
throughput.
Default: 1514
set DPMTU [DPn] | mp1] [1514 | 9014 ]
Requires a SaveConfiguration command
get DPMTU
EthernetSpeed
Specifies the speed of the Ethernet ports. If auto is
enabled, the speed is negotiated. Speeds 10 and 100 are
half duplex 10 base T is only valid for the management
port. Choices are:
10 = 10 baseT
100 = 100 baseT
1000 =1000baseT
Default: auto
set EthernetSpeed [DPn] | mp1] [10 | 100 | 1000 | Auto]
Requires a SaveConfiguration command
get EthernetSpeed [DPn] | mp1| all]
Exit
Exits the current TCP/IP CLI session; it has no effect if
used during a serial CLI session.
Exit
IPAddress
Controls the IP address of the iPBridge Ethernet data
ports. If IPDHCP is enabled, the get command reports
the current IP address assigned by the network DHCP
server, followed by the DHCP identifier.
Default IP addresses:
dp1= [10.0.0.1]
dp2= [10.0.0.2]
dp3= [10.0.0.3]
dp4= [10.0.0.4]
mp1=[10.0.0.5]
set IPAddress [DPn] | mp1] xxx.xxx.xxx.xxx
Requires a SaveConfiguration command
get IPAddress [DPn] | mp1| all]
47
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.6 Ethernet commands
IPDHCP
Selecting DHCP allows the iPBridge to request an IP
address from the network DHCP server. The network
must have at least one DHCP server
Default: enabled
set IPDHCP [DPn] | mp1| all] ] [enabled | disabled]
Requires a SaveConfiguration command
get IPDHCP [DPn] | mp1| all]
IPGateway
Controls the current gateway. If IPDHCP is enabled (see
above), get command reports the current IP gateway
assigned by the network DHCP server
Default: 0.0.0.0
set IPGateway [DPn] | mp1| all] xxx.xxx.xxx.xxx
Requires a SaveConfiguration command
get IPGateway [DPn] | mp1| all]
IPSubnetMask
Controls the current subnet mask. If IPDHCP is enabled
(see above), get command reports the current subnet
mask assigned by the DHCP server
Default: 255.255.0.0
set IPSubnetMask [DPn] | mp1| all] xxx.xxx.xxx.xxx
Requires a SaveConfiguration command
get IPSubnetMask [DPn] | mp1| all]
Password
Specifies a password for all sessions: TCP/IP, FTP and
ExpressNAV web-based interface. You are prompted for
the current password, to enter the new password, and to
confirm the new password. Passwords are case sensitive,
0-32 characters with no spaces.An empty password can
be configured by entering the Password confirmation
prompts with no parameters. The command
RestoreConfiguration default sets the password to its
default value.
Default: Password
set Password
Requires a SaveConfiguration command
Ping
Ping sends an ICMP echo request to the specified host.
ping [DPn] | mp1] [xxx.xxx.xxx.xxx] <count <size>>