ATTO Technology iPBridge 2600 Installation And Operation Manual page 59

SCSITargets
Returns a list of SCSI devices operational on the
referenced SCSI port. Also updates the current logical to
physical address mapping configuration by updating the
status of any online maps/routes to unavailable if a device
is not found or to online if a device is found at the
respective SCSI address.
SCSITargets [sb]
SpeedWrite
When enabled, improves the performance of WRITE
commands to SCSI devices attached to the iPBridge.
Specify SCSI bus (sb), target (st), LUN (sl) of a mapped
SCSI device or (all) for each currently mapped device
set SpeedWrite scsi [sb st sl | all] [enabled | disabled]
get SpeedWrite scsi [sb st sl | all]
SpeedWriteDefault
When enabled, SpeedWrite performance enhancement is
set as the default for any subsequent SCSI devices
mapped manually or via an AutoMap operation. If
disabled, the iPBridge does not attempt SpeedWrite
performance enhancement to newly-mapped SCSI
devices.
Default: disabled
set SpeedWriteDefault [enabled | disabled]
get SpeedWriteDefault
VirtualDriveResponse
Allows the iPBridge to provide proxy responses to SCSI
INQUIRY and TEST UNIT READY commands if a SCSI
device selection times out or is busy. Host systems can
then assign devices consistently regardless of the device's
state during the execution of the commands.
Default: disabled
set VirtualDriveResponse [enabled | disabled]
get VirtualDriveResponse
50
Interfaces: CLI