Atto Ipbridge 2600 Characteristics; Dimensions; Environment; Power - ATTO Technology iPBridge 2600 Installation And Operation Manual

1.1 ATTO iPBridge 2600 characteristics

The ATTO iPBridge 2600 is a 1-Gigabit Ethernet to SCSI 1U full-rack bridge for high performance, cost
effective solutions in enterprise environments.
The iPBridge 2600 is a cost effective, high
performance bridge using four Gigabit Ethernet ports
and two independent Ultra 320 SCSI busses.
Because the iPBridge 2600 provides a compact
embeddable, rack or desktop solution, you can install
the iPBridge in a wide range of system configurations.
Uniquely designed to support the high throughput
needs for applications that require streaming data
transfers (data backup), the iPBridge optimizes
performance by using ATTO Technology intelligent
Bridging Architecture.
• 4 independent 100/1000 GbE RJ45 Ethernet
ports
• Supports IP V 4
• Compliance with IEEE 802.3 GbE
• Supports Microsoft iSCSI Initiator v2.01
• Dual independent Ultra320 LVD/SE SCSI bus
ports.
• Backwards compatible with all low voltage
differential and single-ended SCSI devices.
• RJ-45 Ethernet management port connector
• RS-232 serial console port
• Operating System independent
• Supports all SCSI devices including hard disk
drives, tape drives, RAID controllers, DVD, MO
and CD libraries
• Local diagnostics support through CLI, SNMP,
Telnet, FTP and SCSI Enclosure Services
(SES)
• Command line and menu-based ASCII text
management access via the Ethernet
management port
• FCC Class A, CE EN55022, CE EN55024, CE
60950
• Available as embedded board-level or
desktop/rack mount enclosure
• intelligent Bridging Architecture, the engine
within ATTO iPBridge products, uses ATTO
Data Routing for optimized performance
3
ATTO Technology Inc. iPBridge Installation and Operation Manual

Dimensions

16.91 inches wide (42.95 cm)
Width:
10 inches deep (25.4 cm)
Depth:
1.72 inches high (4.32 cm (1U)
Height:
approximately 8 pounds
Weight:

Environment

Operating temperature:
exceed 40°C.
air enters through slots on the right of the
Airflow:
rear panel and exits through slots on the left of the rear
panel.
5-95% non-condensing
Humidity:

Power

100-240VAC, 1.7-.7A, 50-60 Hz
Input voltage:
Battery-backed event log:
ion battery cell holds the event log memory for up to
30 days. If the iPBridge has been disconnected from
power, recharging begins automatically when power is
restored to the system. The battery is fully charged
after 36 hours of continuous power application.
WARNING
Risk of explosion if battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.

SCSI interface

The two independent SCSI ports on the iPBridge
2600R/D connect storage devices into the Ethernet
Storage Area Network (SAN). Each port is completely
independent from the other.
The ports are Ultra 320 busses with 68-pin VHDCI
connectors, 320 MB/sec. maximum throughput,
downward compatible with all forms of low voltage
differential and single-ended SCSI.
The iPBridge supports all SCSI devices including hard
disk drives, tape drives, RAID controllers and DVD,
MO and CD libraries.
Ambient air should not
A rechargeable Lithium