ATTO Technology iPBridge 2600 Installation And Operation Manual page 50

Help
Displays a list of available commands. If command name
is specified, displays detailed command-specific
information.
Help <command name>
IdentifyBridge
Enabling this option causes the Fault LED on the front
panel of the iPBridge to blink until the parameter is
disabled.
Default: disabled
set IdentifyBridge [enabled|disabled]
get IdentifyBridge
Info
Displays version numbers and other production
information for key components within the iPBridge
Info
IsReserved
Displays the reservation status of the current iPBridge
session/interface.
If set, the configuration image is being modified by
another iPBridge services session: set commands are
temporarily unavailable but information commands are
available.
Executing a SaveConfiguration, RestoreConfiguration or
FirmwareRestart RELEASES the iPBridge so that other
services users may access it.
When iPBridge services interface is RESERVED, set
commands from other users are unavailable.
At least one interface must always have access to the
iPBridge.
IsReserved
Ping
Ping sends an ICMP echo request to the specified host.
ping [DPn] | mp1] [xxx.xxx.xxx.xxx] <count <size>>
RMON
RMON collects and stores Ethernet data on data ports at
specified intervals. Refer to
41
ATTO Technology Inc. iPBridge Installation and Operation Manual
RMON on page 48.
RouteDisplay
Displays a list of iSCSI to SCSI mappings. The optional
LUN parameter limits the list to the map which satisfies
a search for the given LUN.
NumEntries: decimal number of map lines displayed
Target Name: target name
LUN : target LUN
RouteDisplay iSCSI <Target Name> <LUN>
SerialNumber
Reports the iPBridge serial number which is unique for
each iPBridge. The serial number tracks the board
throughout its life and should not be changed for any
reason. Set form requires operator privileges.
get SerialNumber
SNMPDumpMIB
Dumps the contents of the ATTO iPBridge private SNMP
MIB to the current CLI session. Consult your network
administrator for further assistance with SNMP.
SNMPDumpMIB
SNMPExtendedTraps
Controls Extended SNMP map functioning such as device
transition and device error. Consult your network
administrator for further assistance with SNMP.
set SNMPExtendedTraps [enabled|disabled]
get SNMPExtendedTraps
SNMPTrapAddress
Sets/displays the IP trap addresses and levels. Consult
your network administrator for further assistance with
SNMP.
Index: value between 1 and 6
IP Address: standard IP address
Trap Level: severity required for an event to trigger
trap
None: no traps are sent to the address
ALL: all triggering events are sent
.
Warning: warning and critical events are sent
. Critical: only critical events trigger a trap
set SNMPTrapAddress [Index] [IPAddress]
[none | all | warning | critical]
get SNMPTrapAddress