ATTO Technology iPBridge 2600 Installation And Operation Manual page 52

The CLI commands outlined in this chapter may be used to get information or perform functions which
are used in a variety of situations with the ATTO iPBridge.
Date
Sets the date for the iPBridge if SNTP has been disabled
or is not available.
set Date [MM] / [DD] / [YYYY]
Requires a SaveConfiguration command
get Date
FirmwareRestart
Causes the iPBridge to reboot, then re-initialize its
firmware.
FirmwareRestart
MaxOpTemp
Establishes/reports the maximum enclosure temperature
alarm in degrees Celsius. If the temperature of the
iPBridge rises above the maximum MaxOpTemp, thermal
control event handling occurs.
Valid entries are between 55 and 70 degrees C
Default: 70
set MaxOpTemp [55-70]
Requires a SaveConfiguration command
get MaxOpTemp
MinOpTemp
Establishes/reports the minimum enclosure temperature
alarm in degrees Celsius. If the temperature of the
iPBridge falls below the minimum MinOpTemp, thermal
control event handling occurs. Valid entries are between
0 and 15 degrees
Default: 0
set MinOpTemp [0-15]
Requires a SaveConfiguration command
get MinOpTemp
43
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.4 Maintenance commands
OpTempWarn
Controls the number of degrees in Celsius before a
thermal control event handling occurs. Warnings are
made via system log entries. Valid entries are between 0
and 15 degrees
Default: 5
set OpTempWarn [0-15]
Requires a SaveConfiguration command
get OpTempWarn
Password
RestoreConfiguration default sets the password to the
default value
Passwords are case sensitive, 1-32 characters with no
spaces
When the password is all 0s, TCP/IP and ftp do not
validate the password and MD5 authentication are
disabled.
Default: Password
set Password
Requires a SaveConfiguration command
Reserve
Reservation of the iPBridge is implicit: once the
configuration image is changed by any user of services,
the iPBridge becomes RESERVED. Executing a
SaveConfiguration or\ Restore configuration RELEASES
the iPBridge so that other services users may access it.
When iPBridge services interface is RESERVED, set
commands from other users are unavailable.
At least one interface must always have access to the
iPBridge.
Reserve
RestoreConfiguration
Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option undoes any changes made since the last
save.
RestoreConfiguration [Default | Saved]