ATTO Technology iPBridge 2600 Installation And Operation Manual page 61

iSCSITargetNameDisplay
Displays the iSCSI target name.
iSCSITargetNameDisplay
iSCSIWANIPAddress
Sets the IP address reported from the host. Setting the
address to 0.0.0.0 causes the unit to report the LAN IP
address.
Default: 0.0.0.0
set iSCSIWANIPAddress [dp[n] | all] [xxx.xxx.xxx.xxx]
get iSCSIWANIPAddress [dp[n] | all]
iSNSLoginControl
Specifies whether the iPBridge delegates its access
control/authorization to an iSNS server.
Note
iSNSLoginControl cannot be used with
AccessControl
Default: disabled
set iSNSLoginControl [enabled | disabled]
Requires a SaveConfiguration command
get iSNSLoginControl
iSNSServer
Specifies whether the IP address of a valid iSNS server
from which the iPBridge attempts iSCSI initiator
discovery. Setting to 0.0.0.0 disables iSNS server lookup.
Default: 0.0.0.0
set iSNSServer [xxx.xxx.xxx.xxx]
Requires a SaveConfiguration command
get iSNSServer
52
Interfaces: CLI