Installing The Ipbridge; Unpack The Packing Box; Verify Contents; Place The Ipbridge Into Your System; Discover The Ip Address - ATTO Technology iPBridge 2600 Installation And Operation Manual

If you have not already completed the instructions on the Quick Start page packed with your iPBridge,
use the following instructions to install the iPBridge.

Unpack the packing box; verify contents

• The iPBridge
Note the serial number of your iPBridge,
located on the bottom of the unit, for later use:
______________________________
• Serial cable
• Power cord
• "L" brackets and screws
• CD which includes the Installation and Operation
Manual and ATTO QuickNAV.

Place the iPBridge into your system

1 Place the iPBridge on a stable flat surface or
install it into a standard rack.
If installing into a rack, see Exhibit 2.0-1.
a. Attach "L" brackets so that the front side
with the LEDs face front and the connector
side is at the back.
b. Install the iPBridge horizontally within the
rack so it does not reduce the air flow within
the rack.
2 Connect and power up SCSI target devices.
3 Connect the iPBridge Ethernet port to your
network using at least Cat5e cable.
4 Connect the AC power cord from the iPBridge
to the proper AC source outlet.
If you are using a rack:
a. Properly ground the iPBridge to the rack
equipment. The earth ground connection
must be maintained.
b. The power requirements plus the power
draw of the other equipment in the rack
must not overload the supply circuit and/or
wiring of the rack.
5 Turn on the power switch on the iPBridge.
6 Wait up to two minutes for the iPBridge Ready
LED to light indicating the bridge has completed
its power-on self test sequence.
5
ATTO Technology Inc. iPBridge Installation and Operation Manual

2 Installing the iPBridge

Discover the IP address

1 From the CD supplied with your iPBridge, run
the QuickNav Utility QuickNAV-windows.exe
for Windows or QuickNAV-Mac for Mac OS X.
2 Locate the iPBridge with the serial number
recorded earlier.
3 Highlight the serial number.
4 Click Next.
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
_____________________________________
If you do not have a DHCP server, get an
IPaddress and subnet mask from your network
administrator, type it into the area provided, and
select Next. Note the IPAddress and subnet
mask here.
____________________________________
____________________________________
5 Click on Launch Browser

Begin initial configuration

1 The ExpressNAV welcome screen appears.
Click on Enter Here
2 Enter the user name and password.
Note
The default user name is root; it is case
insensitive. The default password is
Password; it is case sensitive. It is best
practice to change the passwords. Refer to
Additional configurations
3 Use the ExpressNAV browser-based interface
to map devices. Refer to
interface on page 25 for information on
ExpressNAV, and refer to
on page 7 for information on mapping.
on page 13.
ATTO ExpressNAV
Target management