ATTO Technology iPBridge 2600 Installation And Operation Manual page 46

These CLI commands are used in a variety of situations
Help
Displays a list of available commands. If command name
is specified, displays detailed command-specific
information.
Help [command name]
Password
Specifies a password for all sessions: TCP/IP, FTP and
ExpressNAV web-based interface. You are prompted for
the current password, to enter the new password, and to
confirm the new password. Passwords are case sensitive,
0-32 characters with no spaces.An empty password can
be configured by entering the Password confirmation
prompts with no parameters. The command
RestoreConfiguration default sets the password to its
default value.
Default: Password
set Password
Requires a SaveConfiguration command
ReadOnlyPassword
Specifies a read only password for all sessions: TCP/IP,
FTP and ExpressNAV web-based interface. You are
prompted for the current password, to enter the new
password, and to confirm the new password. Passwords
are case sensitive, 0-32 characters with no spaces.An
empty password can be configured by entering the
Password confirmation prompts with no parameters. The
command RestoreConfiguration default sets the
password to its default value.
Default: Password
set ReadOnlyPassword
Requires a SaveConfiguration command
ReadOnlyUsername
Specifies a read only user name for all TCP/IP, FTP and
ExpressNAV web server sessions. User name is case
insensitive, 1-32 characters with no spaces.
Default: user
set ReadOnlyUsername
Requires a SaveConfiguration command
get ReadOnlyUsername
7.1.2 General use commands
RestoreConfiguration
Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option undoes any changes made since the last
save.
RestoreConfiguration [Default | Saved]
SaveConfiguration
Many commands require a SaveConfiguration command
to be executed indicated by the return Ready. *.
When you invoke SaveConfiguration, the current
configuration is permanently saved in the iPBridge and
the new configuration becomes the active configuration.
If a firmware restart is required to make the requested
change permanent, a prompt asks you to confirm the
restart. You can override this request by indicating the
override value on the command line.
You may make several changes through commands and
SaveConfiguration before implementing the restart,
but once you have restarted the iPBridge, all the
command changes created before the restart and save are
implemented. If you select the restart option, the iPBridge
executes its complete start up cycle.
Restart or no Restart parameter is optional
SaveConfiguration <Restart| NoRestart>
Username
Specifies a user name for all TCP/IP, FTP and
ExpressNAV web server sessions. User name is case
insensitive, 1-32 characters with no spaces. Changes to
the Admin Level user name requires an Admin Level
password.
Default: root
set Username
Requires entering a password
Requires a SaveConfiguration command
get Username
37
Interfaces: CLI