Ethernet Interface; Serial Interface; Reset Switch; Led Indicators - ATTO Technology iPBridge 2600 Installation And Operation Manual

Ethernet interface

The four independent 100/1000 Ethernet RJ45 data
ports are labeled Ethernet ports 1, 2, 3 and 4. A
separate 10/100 Ethernet standard RJ45 management
port provides monitoring and management through
telnet or ATTO ExpressNAV, a browser-based
interface.
Gb Ethernet cables must be at least CAT-5E certified.

Serial interface

The RS-232 serial port provides support for remote
monitoring and management through a command line
interface. It is set at the factory at 115,200 bps.

Reset switch

A reset switch on the back (connector) side allows
manual restart of the iPBridge using a small sharp
implement inserted into the hole at the back of the
iPBridge.

LED indicators

LED indicators viewed from the front of the iPBridge
2600R/D (see Exhibit 1.1-1):
• Bicolor Ready/Fault: off means not ready; green
on shows ready, and yellow on means fault
• Power: indicates power has been applied.
Exhibit 1.1-1 LED indicators on the front and connector sides of the iPBridge
Serial port R eset sw itch
LED s
R eady/Fault
Ethernet data ports
Ethernet
m anagem ent port
link activity speed
• Each Ethernet data port has two LEDs: when the
speed LED is dark it indicates 100 Mb/sec.
speed; it lights yellow for 1000 Mb/sec. speed.
The activity LED lights green to represent an
active link, blinks to show activity and goes dark
when no link is present.
• SCSI activity is indicated for each port: lighted
green means activity; off shows no activity
LED indicators viewed from the connector (back) side
of the iPBridge 2600R/D (see Exhibit 1.1-1):
• Bicolor Ready/Fault: off means not ready; green
on indicates ready, and yellow on shows fault
• Embedded in the RJ45 connector of the
management port: green on indicates a valid
link; off represents no link present
• Embedded in the RJ45 connector of the
management port: blinks yellow to indicate
management activity
• Embedded in the RJ45 connector of each
Ethernet data port: green on indicates 100
Mb/sec. speed; yellow on indicates 1000
Mb/sec. speed
• Embedded in the RJ45 connector of each
Ethernet data port: solid on represents a link is
present; blinking indicates activity, and off
shows no link is present
• SCSI activity is indicated for each port: on
indicates activity; off shows no activity.
air vents
activity
Installation: ATTO iPBridge 2600R/D
SC SI ports
SC SI activity
4