Atto Ipbridge 1550D; Dimensions; Environment; Power - ATTO Technology 1500D Installation And Operation Manual

The ATTO iPBridge 1550D is a 1-Gigabit Ethernet to Ultra 160 SCSI embeddable bridge for high
performance, cost effective solutions in SMB/SME environments.

Dimensions

7.5 inches wide
Width:
5.0 inches long
Depth:
1.76 inches
Height:

Environment

Operating Temperature:
should not exceed 40°C.
Ambient air
10-90% non-condensing
Humidity:

Power

The iPBridge 1550D uses a 12 volt power brick
connected to an appropriate power source. The
power source must be connected to a protective
earth ground and comply with local electrical
codes. Improper grounding may result in an
electrical shock or damage to the unit.
12v@1.5A
Input voltage:
100-240 VAC, 0.5A@100v, 47-63 Hz

SCSI port

The SCSI port on the iPBridge 1550D connects
storage devices into the Storage Area Network
(SAN). The port is an Ultra 160 LVD/SE SCSI
bus with 68-pin "P" interface; downward
compatible with all forms of low voltage
differential and single-ended SCSI.
The iPBridge supports SCSI devices including
hard disk drives, tape drives, RAID controllers,
DVD and CD libraries.
7
ATTO Technology Inc. iPBridge Installation and Operation Manual

1.3 ATTO iPBridge 1550D

0-70° C external

Ethernet port

The 100/1000 GbE RJ45 Ethernet port uses the
Intel 8254x family gigabit Ethernet chipset to
support iSCSI data transfer and inbound
management through an ASCII-based command
line interface or ATTO ExpressNAV, a browser-
based interface.
GbE cables must be at least CAT-5E certified for
1000 Mb/sec. use.
LED indicators
Ready/SCSI Port Activity:
top and on the back of the iPBridge lights solid
green to indicate Ready and blinks to show SCSI
activity and to identify the unit when commanded
by software.
two LEDs are integrated into the
Ethernet port:
Ethernet connector. One lights solid green to
denote a complete link and blinks green to show
activity. A bicolor green/yellow LED lights
yellow to indicate 1 Gb/sec. transmission speed
and lights green to show 100 Mb/sec. speed.

Reset switch

A manual reset switch is mounted on the back of
the iPBridge to restore factory defaults.
a green LED on the