ATTO Technology 1500D Installation And Operation Manual page 58

These commands configure the Ethernet port including Telnet parameters.
DPMTU
Controls the MTU (Maximum Transmission Unit) used by
the data port: increasing the MTU may improve
throughput on the ipBridge data ports.
Default: 1514
set DPMTU dp0 [1514 | 9014]
Requires a SaveConfiguration command
get dp0 DPMTU
EthernetSpeed
Specifies the speed of the Ethernet port. If auto is enabled,
the speed is negotiated.10 and 100 speeds are half duplex
Ethernet speed settings in the host must be the same as
Ethernet speed settings in the iPBridge. Choices are 10
(10 baseT), 100 and 1000
Default: auto
set EthernetSpeed dp0 [10 | 100 | 1000| Auto]
Requires a SaveConfiguration command
get EthernetSpeed dp0
Exit
Exits the current Telnet CLI session; it has no effect if
used during a serial CLI session.
Exit
IPAddress
Controls the IP address of the iPBridge Ethernet data
ports. If IPDHCP is enabled, the get command reports
the current IP address assigned by the network DHCP
server followed by the DHCP identifier.
Default IP address: 10.0.0.1
set IPAddress dp0 xxx.xxx.xxx.xxx
Requires a SaveConfiguration command
get IPAddress [dp0|all]
IPDHCP
Selecting DHCP allows the iPBridge to request an IP
address from the network DHCP server. The network
must have at least one DHCP server.
Default: enabled
set IPDHCP [dp0|all] [enabled | disabled]
Requires a SaveConfiguration command
get IPDHCP dp0
49
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.7 Ethernet commands
IPGateway
Controls the current gateway. If IPDHCP is enabled (see
above), get command reports the current IP gateway
assigned by the network DHCP server.
Default: 0.0.0.0
set IPGateway dp0 xxx.xxx.xxx.xxx
Requires a SaveConfiguration command
get dp0 IPGateway.
IPSubnetMask
Controls the current subnet mask. If IPDHCP is enabled
(see above), get command reports the current subnet
mask assigned by the DHCP server.
Default: 255.255.0.0
set IPSubnetMask dp0 xxx.xxx.xxx.xxx
Requires a SaveConfiguration command
get dp0 IPSubnetMask
iSCSIWANIPAddress
Sets the IP address reported from the host. Setting the
address to 0.0.0.0 causes the unit to report the LAN IP
address.
Default: 0.0.0.0
set iSCSIWANIPAddress [dp0 | all] [xxx.xxx.xxx.xxx]
get iSCSIWANIPAddress [dp0 | all]
Password
Specifies a password for all sessions: Telnet, FTP and
ExpressNAV web-based interface. You are prompted for
the current password, to enter the new password, and to
confirm the new password. Passwords are case sensitive,
0-32 characters with no spaces. An empty password can
be configured by entering the Password confirmation
prompts with no parameters. The command
RestoreConfiguration default sets the password to its
default value.
Default: Password
set Password
Requires a SaveConfiguration command
Ping
Sends an ICMP echo request to the specified host.
ping dp0 [xxx.xxx.xxx.xxx] <count <size>>