Speedwrite; Speedwritedefault; Time; Timezone - ATTO Technology 1500D Installation And Operation Manual

SpeedWrite

When enabled, improves the performance of SCSI WRITE
commands to SCSI devices attached to the iPBridge.
Specify SCSI bus (sb), target (st), LUN (sl) of a mapped
SCSI device or (all) for each currently mapped device.
set SpeedWrite SCSI [sb st sl | all] [enabled|disabled]
get SpeedWrite SCSI [sb st sl | all]

SpeedWriteDefault

When enabled, SpeedWrite performance enhancement is
set as the default for any subsequent SCSI devices
mapped manually or via an AutoMap operation. If
disabled, the iPBridge does not enable SpeedWrite
performance enhancement to newly-mapped SCSI
devices.
Default: disabled
set SpeedWriteDefault [enabled | disabled]
get SpeedWriteDefault

Time

Controls the time for the iPBridge if SNTP has been
disabled or is not available.
set Time [HH]: [MM]: [SS]
Requires a SaveConfiguration command
get Time

TimeZone

Controls the time zone for the iPBridge if SNTP has been
disabled or is not available. Choices are EST, CST,
MST, PST or numerical offset from GMT in the form of
.
+/-:HH:MM.When SNTP is enabled, the iPBridge
applies the time zone setting to the time retrieved from a
specified SNTP time server to determine local time.
Default: EST
set TimeZone [ [EST | CST | MST | PST] [+ / - HH :MM ] ]
Requires a SaveConfiguration command
get TimeZone

Username

Specifies user name for all Telnet, FTP and ExpressNAV
web server sessions.The username is case insensitive, 1-
32 characters, no spaces You must have the Admin
password to change Username.
Default: root
set Username [username]
Requires a SaveConfiguration command
get Username
42
CLI commands