ATTO Technology 1500D Installation And Operation Manual page 59

ReadOnlyPassword
Specifies a read only password for all sessions: Telnet,
FTP and ExpressNAV web-based interface. You are
prompted for the current password, to enter the new
password, and to confirm the new password. Passwords
are case sensitive, 0-32 characters with no spaces.An
empty password can be configured by entering the
password confirmation prompts with no parameters. The
command RestoreConfiguration default sets the
password to its default value.
Default: Password
set ReadOnlyPassword [password]
Requires a SaveConfiguration command
ReadOnlyUsername
Specifies a read only user name for all Telnet, FTP and
ExpressNAV web server sessions. Username is case
insensitive, 1-32 characters with no spaces.
Default: user
set ReadOnlyUsername [username]
Requires a SaveConfiguration command
get Username
RMON
RMON collects and stores Ethernet data on data ports at
specified intervals. You can display the entire table
requested, or a single entry based on the index (and
sample index for the Ethernet History table).
Entries in the Ethernet History table are not valid when
their Sample Index is 0.
Exhibit 7.1.7-1 Default history Control table (buckets and interval in hexadecimal) for the RMON CLI
command.
Idx DataSrc
====================================================================
001 43.6.1.2.1.2.2.1.1.1 00000032 00000032 0000001e monitor 00000004
002 43.6.1.2.1.2.2.1.1.1 00000032 00000032 00000708 monitor 00000004
003 43.6.1.2.1.2.2.1.1.2 00000032 00000032 0000001e monitor 00000004
004 43.6.1.2.1.2.2.1.1.2 00000032 00000032 00000708 monitor 00000004
005 43.6.1.2.1.2.2.1.1.3 00000032 00000032 0000001e monitor 00000004
006 43.6.1.2.1.2.2.1.1.3 00000032 00000032 00000708 monitor 00000004
Setting the history control entries take effect immediately,
but changes must be saved to be persistent over a reboot.
RMON [idx] [bucketsRequest] [interval] [valid| invalid]
For entire table: get RMON [ethernetStat | historyControl]
For single index entry: get RMON ethernetHistory <idx
Username
Specifies a user name for all Telnet, FTP and
ExpressNAV web server sessions. Username is case
insensitive, 1-32 characters with no spaces.You must
have an Admin password to change Username.
Default: root
set Username [username]
Requires entering a password
Requires a SaveConfiguration command
get Username
VLAN
Creates up to eight Virtual LAN IDs for each Ethernet
data port. Each VLAN ID is assigned a VLAN name of up
to 64 characters. If no VLALN ID exists for a data port,
VLAN is disabled for that port.Refer to
optimization
set VLAN [dp [n]] [[VLAN ID] [VLAN Name] <delete>| [all]
Requires a SaveConfiguration command
get VLAN [dp [n]]
BktReq BktGrant Interval Owner
Valid range for buckets Request: 1-180
Valid range for ethernetStat index: 1-3
Valid range for historyControl: 1-6
Valid range for EthernetHistory index: 1-6
Valid range for sampleidx: 1-2147483647
Valid range for interval: 1-3600
<idx>
sampleIdx>
on page 19.
[delete]]
Performance
Status
50
CLI commands