ATTO Technology 1500D Installation And Operation Manual page 54

7.1.5 SCSI configuration commands
The SCSI ports are configured with default settings but may be customized to your specifications using
the CLI commands in this section.
SCSIInitID
Specifies the persistent SCSI initiator ID to be used on the
specified SCSI port. All maps coinciding with the user-
specified SCSIInitID must be set to offline and become
invalid upon issuing this command. Choices are 0 to 15.
Default: 7
set SCSIInitID [sb [0-15] ]
Requires a SaveConfiguration command
get SCSIInitID
SCSIPortBusSpeed
Controls the transfer rate at which the iPBridge attempts
to negotiate with its SCSI devices.
Default: Ultra 160
set SCSIPortBusSpeed [sb [fast | ultra | ultra2 | ultra160 ]
Requires a SaveConfiguration command
get SCSIPortBusSpeed [PortNum]
SCSIPortList
Returns a list of available SCSI ports and their current
status. Valid status values are O.K. and Failed.
SCSIPortList
SCSIPortReset
Resets the specified SCSI bus.
SCSIPortReset [sb]
SCSIPortResetOnStartup
Specifies whether or not the SCSI port is reset on power-
up.
Default: enabled
set SCSIPortResetOnStartup [sb [enabled | disabled] ]
Requires a SaveConfiguration command
get SCSIPortResetOnStartup [sb]
SCSIPortSelTimeout
Indicates the time, in milliseconds, that the bridge waits
for a response from a SCSI device on the selected port
after a selection request.
get SCSIPortSelTimeout [sb]
SCSIPortSyncTransfer
Specifies whether synchronous SCSI transfers should be
negotiated with devices on the specified SCSI port.
45
ATTO Technology Inc. iPBridge Installation and Operation Manual
Default: enabled
set SCSIPortSyncTransfer [[sb [enabled | disabled] ]
Requires a SaveConfiguration command
get SCSIPortSyncTransfer [sb]
SCSIPortTermination
Configures/reports the SCSI internal termination of the
SCSI port identified.Enabling termination allows the
iPBridge to act as a terminator at the end of a SCSI chain.
Default: enabled
set SCSIPortTermination [sb [enabled | disabled]]
Requires a SaveConfiguration command
get SCSIPortTermination [sb]
SCSIPortWideTransfer
Specifies whether wide SCSI transfers should be
negotiated on the specified bus.
Default: enabled
set SCSIPortWideTransfer [sb [enabled | disabled] ]
Requires a SaveConfiguration command
get SCSIPortWideTransfer [sb]
SCSITargetLUNs
Sets the maximum number of SCSI LUNs per target the
FibreBridge attempts to query during a SCSI bus scan.
Choices are 8 and 32.
Default: 8
set SCSITargetLUNs [sb] [8 | 32]
Requires a SaveConfiguration command
get SCSITargetLUNs
SCSITargets
Lists the physical devices connected and running on the
specified SCSI port.
SCSITargets [n]
SpeedWrite
When enabled, improves the performance of WRITE
commands to target devices attached to the iPBridge.
Specify SCSI bus (sb), target (st), LUN (sl) of a mapped
SCSI device or (all) for each currently mapped device
set SpeedWrite SCSI [sb st sl | all] [enabled | disabled]
get SpeedWrite SCSI [sb st sl | all]