Check Host Versions; Check Ipbridge Product Versions; Component Check; Checking Scsi Devices - ATTO Technology 1500D Installation And Operation Manual

Check host versions

Check the following to find problems on attached
hosts:
• Operating system version
• Service pack version
• Host adapter version
• Host adapter firmware version

Check iPBridge product versions

For a current list of required updates, visit
www.attotech.com.
1 If you have not already, open an ExpressNAV
session. For instructions, refer to
ExpressNAV session

Component check

Use this procedure to check system components. For
more information on the commands used in this
procedure, refer to CLI provides ASCII-based
interface on page 35.

Checking SCSI devices

1 Check SCSI devices to make sure they are all
set to different SCSI IDs.
By default, the iPBridge SCSI ports use SCSI
ID 7 so drives should use IDs 0 through 6 and 8
through 15.
2 Check the SCSI device power. Make sure the
devices are powering up.
3 Watch the drive lights before, during, and after
startup. Many drives have term power lights
that should be on before startup and turn off
when system boots.
4 Verify the external terminator is the correct type
and does not have damaged pins.
5 Check cable integrity. Check the cables for
solid connections. Make sure they are screwed
down. Inspect cable ends for bent pins.
6 If termination is correct, and the problem
persists, try drives one at a time with different
cables, adding drives and cables until the
problem occurs. This helps pinpoint the drive or
cable causing the problem.
7 Check with the manufacturer of SCSI device(s)
for further troubleshooting methods.
If SCSI devices appear to be working, continue to
the iPBridge SCSI port section.
Opening an
on page 29
• Host adapter device driver version
• iSCSI driver version
If an update is required, perform the update. For an
updated list of supported iPBridge host platforms and
host adapters, visit www.attotech.com.
Go to the Status page and check the version
number.
2 If you need to update, download the update
www.attotech.com.
from
Refer to Updating firmware

Checking the iPBridge SCSI ports

1 Verify the iPBridge has its termination set
properly. By default, termination is
2 Either through the ATTO ExpressNAV or CLI,
perform a SCSI bus scan on each SCSI port.
Refer to Opening an ExpressNAV session
or
page 29 iSCSI commands
If no devices appear, re-check SCSI cables and
termination. If garbage information appears,
the problem is most likely a bad SCSI cable or
termination.
3 Check the internal cabling of the SCSI device.
LVD SCSI cable lengths are limited to 12.5
meters. Longer cable lengths can cause
problems. Internal cabling is also considered
when calculating total cable length. For details,
refer to Cabling on page iii.
4 Some older SCSI devices improperly negotiate
with the iPBridge SCSI port. If older devices are
not showing up, contact your service
representative.
5 If all devices appear, invoke the ScsiTargets
command several times on each SCSI port to
verify that the devices can be seen. If devices
disappear then appear again, the problem is
most likely a SCSI cable. For information on the
ScsiTargets command, refer to
commands on page 51.
If all devices appear and remain, move to the
iPBridge internal configuration section.
on page 25.
enabled
.
on
on page 51.
iSCSI
24
Troubleshooting