ATTO Technology 1500D Installation And Operation Manual page 60

You may customize the iPBridge to your specifications using the CLI commands in this section.
iSCSIAlias
Assigns a human-readable name to the iPBridge. Aliases
may be 1 to 64 characters long and may contain spaces if
spaces are enclosed in quotation marks. Entering the set
iSCSIAlias command with no alias parameter causes
the alias to be removed.
Default: ""
set iSCSIAlias [Alias]
Requires a SaveConfiguration command
get iSCSIAlias
iSCSIChap
Regulates whether CHAP (Challenge-Handshake
Authentication Protocol) is used for the iSCSI protocol. If
CHAP is enabled, the target requires the initiator to
negotiate CHAP authentication using the CHAP secrets.
An initiator may reject this negotiation. If discovery is
specified, the setting applies to CHAP during discovery
sessions.
Default:disabled
set iSCSIChap [default | Target Name | discovery ]
[enabled | disabled]
get iSCSIChap [default | Target Name | discovery ]
iSCSIChapSecret
Specifies the incoming and outgoing passwords (secrets)
for iSCSI CHAP sessions. RestoreConfiguration
default sets the CHAP secret passwords pair to default
values.
Secrets are case sensitive, 12 to 32 characters, and
cannot contain spaces. In and out secrets must be
different for each name.If discovery is specified, the
setting applies to CHAP during discovery sessions.
An in CHAP secret is for authentication of the server to
the iPBridge. The iPBridge can store up to 32 in secrets,
each with a unique Account Name (optionally the
Initiator Name) and secret pair. The Account Name
51
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.8 iSCSI commands
can be 1 to 223 characters. Account Names are case
sensitive. Account name can not be all.
An out chap secret is for authentication of the iPBridge
to the rest of the network. There can only be one out
secret. The account name is ignored for out secrets and
defaulted to root.
set iSCSIChapSecret [default | Target Name | discovery ]
[in [Account Name | all] | out [root] | delete [Account
Name | all ] ] <Secret>
get iSCSIChapSecret [default | Target Name | discovery
][ in [Account Name | all] | out [root]]
iSCSIIntiators
Lists previous and current successfully logged-in iSCSI
initiators including successful initiators recorded in the
event log and any initiators manually added since the last
reboot. This list is cleared if the event log is cleared.
iSCSIIntiators
iSCSIPortNumber
Specifies the port number which listens for iSCSI
connections. The port number must be between 1024 and
65535 except for port 860.
Default: 3260
set iSCSIPortNumber [dp0 | all] [portnumber]
Requires a SaveConfiguration command
get iSCSIPortNumber [dp0] | all]
iSCSITarget
Creates/deletes an iSCSI target name. The target name
acts as a suffix to the standard bridge iSCSI-qualified
name. The target name may not exceed 24 characters. A
newly-created target has one LUN, the iPBridge LUN, at
LUN 0. If the target name already exists, this command
does nothing. In verbose mode, overwriting a map
requires secondary confirmation of the action.
iSCSITarget [Target Name] <delete>