Bridge Configuration; Firmware Update; Advanced Cli Configuration; Restart - ATTO Technology 1500D Installation And Operation Manual

Bridge Configuration

Defines a name for the bridge, sets an administrator
user name and password, a read only user name and
password, restores defaults and controls the Identify
Bridge feature.
Refer to Maintenance commands
details on each parameter.

Firmware Update

You may update firmware using ExpressNAV. Refer
to Updating firmware on page 22.

Advanced CLI Configuration

Allows you to input any CLI command available
through the iPBridge. See Exhibit 6.1-1 for an
example.
1 Type in the CLI command
2 Click the Submit button.
A text field beneath the box lists the most recent
commands issued to the iPBridge through this
page.
If you enter an incorrect parameter, the CLI
help text is displayed, showing the parameters
available.
3 If your entry was correct, type
saveconfiguration
4 Click the Submit button. Your changes are
implemented.

Restart

Implements a firmware restart of the bridge and makes
permanent any changes you have made since the last
firmware restart.
Exhibit 6.1-1 CLI commands entered on the Advanced CLI page.
1
2
on page 41 for

Help

Gives help information about the command line
interface commands and troubleshooting tips via links
to pages with help text for each category of options
and one link to the Troubleshooting Tips and FAQs
page on the ATTO website, www.attotech.com, or
from the CD included with your iPBridge.
Contact information for ATTO technical support is on
the right. Help is always available by pressing any
word shown in red on the screen.
Click the Restart button.
A box tells you to wait until the counter gets to
0 and then the browser refreshes.
If the browser does not refresh after the counter
gets to 0, click the link to refresh it manually.
Note
Restarting the firmware may take a few
minutes.
32
User infterface