Atto Ipbridge 1500E; Dimensions; Power; Reset Switch - ATTO Technology 1500D Installation And Operation Manual

The ATTO iPBridge 1500E is a 1-Gigabit Ethernet to SCSI embeddable bridge for midrange
performance, cost effective solutions in SMB/SME environments.
The iPBridge 1500E includes a single Ethernet
port which may be used for either data transfer or
configuration, a serial management port and a

SCSI port.

Dimensions

6.4 inches
Length:
4.4 inches
Width:
Height of the tallest component:
Environment
Operating Temperature:
Ambient air should not exceed 40°C.
10-90% non-condensing
Humidity:
Recommended airflow:

Power

The iPBridge1500E board may be powered from
a 4-pin connector.
12V DC ±10% derived from a 4-
Input voltage:
pin connection.
12V, 1.7 amps
Power draw:
4- pin power connector pin outs
Pin Description
1 12 volt input
2 Ground
3 Ground
4 No connect

Reset switch

A manual reset switch is mounted on the board
near the serial port.
SCSI port
The SCSI port on the iPBridge 1500E connects
storage devices into the Storage Area Network
(SAN). The port is an Ultra 3 LVD/SE SCSI bus
with 68-pin "P" interface: 160 MB/sec. maximum
throughput, downward compatible with all forms
of single-ended SCSI.
5
ATTO Technology Inc. iPBridge Installation and Operation Manual

1.2 ATTO iPBridge 1500E

.536 inches
5-40° C external
11 cubic feet per minute
The iPBridge supports SCSI devices including
hard disk drives, tape drives RAID controllers,
DVD, MO and CD libraries.

Ethernet port

The 10/100/1000 GbE RJ45 Ethernet port uses the
Intel 8254x family gigabit Ethernet chipset to
support Telnet-based data transfer and
management through a an ASCII-based command
line interface or ATTO ExpressNAV, a browser-
based interface.
GbE cables must be at least CAT-5E certified for
1000 Mb/sec. use.

Serial port

The RS-232 serial port provides support for
remote monitoring and management through a
command line interface. It is set at the factory at
115,200 bps.
Pin outs of the RJ11
connector, part
number CBL-0911-001
Pin Description
2 TXD
3 Ground
4 RXD
5 Ground

LED indicators

A green LED in the middle of the
Activity:
iPBridge blinks to show the unit is ready and to
identify the iPBridge when the CLI command
IdentifyBridge is enabled. It goes dark when
there is SCSI activity.
the SCSI bus has an LED which is
SCSI Activity:
lit when the iPBridge is ready and goes dark when
there is SCSI activity.