ATTO Technology 1500D Installation And Operation Manual page 52

ATTO iPBridge diagnostic commands help validate iPBridge operation and diagnose/isolate iPBridge
faults. For more information on SNMP, refer to
BridgeModel
Reports model and firmware information about a specific
iPBridge
get BridgeModel
BridgeName
Specifies name used to identify individual iPBridge units.
May be up to a maximum of eight characters. It is not the
World Wide Name (WWN).
set BridgeName [value]
get BridgeName
ClearEventLog
Clears the contents of the event log. No events are
recorded until the command has been completed.
ClearEventLog
DumpConfig
Displays a unit's configuration to an RS-232 or TCP/IP
session (over Ethernet) without impact on the log itself
(the log is not cleared). No events are recorded until the
command has been completed.
DumpConfig
DumpEventLog
Dumps the contents of the entire event log to an RS-232
or TCP/IP session (over Ethernet) without impact on the
log itself. (the log is not cleared). No events are recorded
until the command has been completed.
DumpEventLog
EventLog
When enabled, records various system events to the event
log.
Default: enabled
set EventLog [enabled|disabled]
Requires a SaveConfiguration command
get EventLog
43
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.4 Diagnostic commands
Remote system monitoring
Help
Lists available commands. If command name is specified,
displays detailed command-specific information.
Help [command name]
IdentifyBridge
Enabling this option causes the LED on the top panel of
the iPBridge to blink until the parameter is disabled.
Default: disabled
set IdentifyBridge [enabled|disabled]
get IdentifyBridge
Info
Displays version numbers and other production
information for key components within the iPBridge.
Info
iSCSITargetNameDisplay
Displays the iSCSI target name.
iSCSITargetNameDisplay
IsReserved
Displays the reservation status of the current iPBridge
session/interface.
If the display shows the iPBridge is reserved, the
configuration image is being modified by another
iPBridge services session: set commands are temporarily
unavailable but information commands are available.
Other users may access the iPBridge after execution of a
SaveConfiguration, RestoreConfiguration or
FirmwareRestart.
At least one interface must always have access to the
iPBridge. Refer to
IsReserved
Ping
Ping sends an ICMP echo request to the specified host.
ping dp0 [xxx.xxx.xxx.xxx] <count <size>>
on page 21.
Reserve on page 41.