3.5.5.3 Receive PGN 127501 via 126208
This parameter allows you to configure whether the device will respond to the NMEA
command of an indicator in the 127501 Binary Status Report message. If this field is set, the
device will respond to that message. If this field is cleared, the device will not respond to that
message, but only to proprietary messages.
3.5.5.4 Transmit 127508
This parameter allows you to configure whether the device will transmit the 127508 Battery
Status message to indicate the box temperature, input voltage, and input current. If this field is
set, the device will transmit the 127508 message. If this field is cleared, the device will not
transmit the 127508 message.
3.5.5.5 Send Extended Status
This parameter allows you to configure when the CLMD12 sends the extended box status
proprietary message. There are two settings for this parameter:
• Only send when an error is detected
• Only send upon request
3.5.5.6 127501 via 126208 Receive Filter
This parameter allows you to configure from which devices the CLMD12 will accept 126208
NMEA Commands of the 127501 Binary Status Report message. There are two settings for
this parameter:
• From Carling/Maretron devices only
• From any manufacturer's device
3.5.5.7 Box Status
3.5.5.7.1 Box Current
This read-only field indicates the total current passing through the device.
3.5.5.7.2 Box Temperature
This read-only field indicates the internal temperature of the device.
3.5.5.7.3 Main Box Voltage
This read-only field indicates the voltage of the power input for the device.
3.5.6 Installation Description
This tab allows you to set values for the installation description properties of the device.
Revision 1.6
Page 25