Nmea 2000; Figure 3 - Clmd12 Side View - Maretron MPOWER CLMD12 User Manual

2) the output channel (breaker) connections (J1), which are described in Section 3.4.2,
3) the discrete input signal connections (J2), which are described in Section 3.4.3, and
4) the DC power connection stud, which is described in Section 3.4.4.

3.4.1 NMEA 2000

connector can be found on the side of the enclosure and labeled "J3". The
®
The NMEA 2000
®
NMEA 2000 connector is a round five-pin male connector (see Figure 4). You connect the
CLMD12 to an NMEA 2000
by connecting the female end of the cable to the CLMD12 (note the key on the male connector
and keyway on the female connector). Be sure the cable is connected securely and that the
collar on the cable connector is tightened firmly. Connect the other end of the cable (male) to
®
the NMEA 2000 network in the same manner. The CLMD12 is designed such that you can plug
or unplug it from an NMEA 2000
disconnected. Please follow recommended practices for installing NMEA 2000
products.
Revision 1.6
Figure 3 – CLMD12 Side View
®
Connection
®
network using a Maretron NMEA 2000
®
network while the power to the network is connected or
Figure 4 – NMEA 2000
®
Connector (J3) Face Views
®
cable (or compatible cable)
®
network
Page 9