CLMD12 User's Manual
3.5.2 Flash Map
The Flash Function allows control of a breaker to be periodic. Common uses of this function
include turning off a head fan or light after a set period of time, etc. Three parameters dictate
the behavior of the circuit and are detailed below. A maximum of 15 flash table entries may be
defined.
Figure 6 – CLMD12 Flash Map Tab
3.5.2.1 Cycles
This parameter allows you to configure the number of cycles that this flash map will execute
after a breaker configured to use this flash map has been switched to the ON state. A value of
Page 18
Revision 1.6