Operational Check - Assa Abloy Corbin Russwin ED5200N S Series Installation Instructions Manual

ED5000N (S)(A) Series Exit Device
8) Surface Vertical Rod Installation Instructions (Continued)
4. Install Inside Escutcheon
a. Position inside gasket and escutcheon against door. Verify that no
wires are being pinched.
b. Mount inside escutcheon assembly to plate using (2) #8-32 x 5/8"
Phillips flat head undercut machine screws.
Before closing door test for cylinder function of lock cylinder and Inside lever:
a. Insert key into cylinder and rotate.
b. The key will retract the latch. Key should rotate freely.
c. Inside lever retracts latch.
d. Close door, ensure latch fully extends into strike and does not bind.
Note: Fail safe trim cylinder will have to be tested after wiring
is complete and power is turned on.
Note: Once electrical wiring has been successfully
completed according to proper application, follow
the following step:
a. Turn power ON at EAC panel.
b. Verify LED located on reader is ON (Red or Green
depending on reader configuration (See reader LED
Configuration).
c. Present proximity credential and verify LED and
sounder activity.
d. Verify valid card read at EAC Panel.
e. Verify system operation functions; i.e., when prox credential
is presented to reader that the door unlocks.

9) Operational Check

16
Fig. 4
Copyright © 2018 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.