Assa Abloy Corbin Russwin ED5200N S Series Installation Instructions Manual page 9

Exit devices

Hide thumbs Also See for Corbin Russwin ED5200N S Series:

Table of Contents

ED5000N (S)(A) Series Exit Device

Install Outside Trim

a. Make sure tailpiece is oriented vertically.

b. Feed trim wire harness through wire harness hole (Fig. 3a).

c. Mount trim assembly to door pulling slack wire towards device side of door.

Note: Be careful not to pinch wire harness.

d. When mounting trim, lift tailpiece to pass through hole on device side.

Note: Make sure tailpiece is still oriented vertically.

e. Fasten trim assembly to door using (2) 1/4-20 oval head screws and (2) finish washers (Fig. 3b).

Note: Finger tighten only.

Trim

Wire Harness

and Ground

Tailpiece must be

in vertical position

Fig. 3a

7) Installation Instructions (Continued)

Wire

Harness

Hole

Reproduction in whole or in part without the express written

Fig. 3b

permission of Corbin Russwin, Inc. is prohibited.

Table of Contents

Corbin russwin ed5200n a series