ED5000N (S)(A) Series Exit Device
7) Installation Instructions (Continued)
5.
Install Head Cover:
a. Lay wire harnesses (trim harness and device harness) across ¾" hole (Fig. 5a).
b. Tuck wires into hole when installing cover so that wires are not pinched between head cover and door.
c. Attach head cover using (2) #8-32 flat head screws (Fig. 5b).
Use 3/4" hole to
tuck trim and
device wire
harness under
head cover,
Fig. 5a
Fig. 5b
Copyright © 2018 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
11
permission of Corbin Russwin, Inc. is prohibited.