Installation Instructions - Assa Abloy Corbin Russwin ED5200N S Series Installation Instructions Manual

ED5000N (S)(A) Series Exit Device
1. Verify Hand and Bevel of door.
Door should be fitted and hung.
Verify box label for size of exit device,
function and hand.
2. Trim Assembly Instructions:
a. Check cylinder components:
Cylinders longer than 1-1/8" (29mm) require collars.
Refer to Cylinder Collar Chart (Fig. 2a).
b. If required, modify by cutting cylinder tailpeice:
Correct length is 1/16" to 3/16" (2 to 5mm)
beyond cylinder housing cam.
c. Assemble cylinder:
1. Insert cylinder housing prongs into matching
notches of escutcheon.
2. Pass cylinder tailpeice through cylinder
collar (if required) and slot in cylinder cam.
3. Fasten cylinder in escutcheon recess or
collar using 2 mounting screws.
Do not overtighten screws.
d. **Escutcheon Assembly (Fig. 2b):
The lever is handed (LHR shown).
Note: Lever Return Spring is handed.
Hand cannot be changed without correct spring.
Lever Return Spring handing can be identified by
the color of the spring:
• LHR: Part Number 651F618 (Red)
• RHR: Part Number 651F628 (Blue)

7) Installation Instructions

Cylinder Collar
(if necessary)
Cam must be postitioned as shown
when cylinder tailpiece is assembled
Inside
Left Hand
Reverse
LHR
Outside
Fig. 1
Cylinder Collar Chart
Cylinder Length
Inches
1-1/8" 29mm
1-1/4" 32mm
1-1/2" 38mm
*Specify Finish
(2) Cylinder Mounting Screws
(supplied with cylinder)
Rim Cylinder
Fig. 2b
Copyright © 2018 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
8
Right Hand
Reverse
RHR
Collar
Millimeters
None
422F88*
686F98*
Fig. 2a
Cylinder
Tailpiece
permission of Corbin Russwin, Inc. is prohibited.