Assa Abloy Corbin Russwin ED5200N S Series Installation Instructions Manual page 15

ED5000N (S)(A) Series Exit Device
8) Surface Vertical Rod Installation Instructions (Continued)
3. Attach Connectors (Interior PCB Assembly)
a. Connect P5 (7-pin connector) from Reader board to J5
on interior PCB assembly (Fig 3a and 3b).
b. Connect ElectroLynx harness (4 and 8-pin) from door
harness to ElectroLynx harness on interior PCB assembly
(Fig 3a and 3b).
c. Connect P3 (2-pin connector) from lockbody to J3 and
P4 (6-pin connector) from lockbody to J4 on interior PCB
assembly (Fig 3a and 3b).
NOTES:
Neatly fold the wires onto themselves and into the remaining
space along side the mounting bracket to prevent pinching wires
when mounting escutcheon.
Connectors go on only one way.
Do not offset connector and be sure they are completely seated.
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
1-Violet Lock
DC Neg
(Solenoid, neg)
2-Gray, Lock
DC Pos
(Solenoid, pos)
J1
3 - Pink 1- Black 3-White
NOT PWR GND Wiegand
USED DATA 1
4-Tan 2-Red 4-Green
NOT PWR 12VDC Wiegand
USED DATA 0
Mounting Bracket
Mounting Plate
(2) Mounting
Plate Screws
1
2
3
J2
To ElectroLynx Harness
From Chassis
Body P4 to J4
5-Orange 7-Brown
RX (N/O) EGND
6-Blue 8-Yellow
RX (COM) LED
2
J5
To ElectroLynx
Harness
J4
From Chassis
Body P4 to J4
3
Fig. 3b
15
J5
J4
J3
Fig. 3a
From Reader
Board P5 to J5
1
J3
From Electric
Trim
Body P3 to J3
Copyright © 2018 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
From Reader
Board P5 to J5
J1
From Electric
Trim
Body P3 to J3