Assa Abloy Corbin Russwin ED5200N S Series Installation Instructions Manual page 13

ED5000N (S)(A) Series Exit Device
7. Install Inside Escutcheon:
a. Make electrical connections (Step 8).
b. Feed excess ElectroLynx® wire harness back into door.
c. Feed excess trim and exit device under head cover.
d. Install inside escutcheon using (2) #8-32 x 5/8"
oval head screws.
Note: Be careful not to pinch wires between
escutcheon and door surface.
Notes:
• Insert the ElectroLynx 8- and 4-pin
connectors and establish their
position inside the door prep.
• Neatly fold the wires onto
themselves and into the
remaining space to prevent
pinching wires when mounting escutcheon.
8. Attach Connectors (Interior PCB Assembly):
a. Connect P3 (2 Pin Connector) from trim to J3 on interior PCB
assembly (Fig 8).
b. Connect P4 (6 Pin Connector) from exit device to J4 on
interior PCB assembly.
c. Connect P5 (7 Pin Connector) from Reader PCB to J5
on interior PCB assembly.
d. Connect ElectroLynx®Harness (4 Pin & 8 Pin) from door
harness to ElectroLynx harness on Interior PCB Assembly.
e. Place extra wire inside door hole.
Note: Connectors go on only one way.
Do not offset connector and be sure they are
completely seated.
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
1-Violet Lock Neg
(Solenoid, neg)
2-Gray Lock Pos
(Solenoid, pos)
7) Installation Instructions (Continued)
J1
3-Pink 1- Black
- PWR NEG
4-Tan 2-Red
- PWR POS
ElectroLynx
Harness
From Lock
Body P4 to J4
3-White 5-Orange 7-Brown
DATA 1 RX (NO) EGND
4-Green 6-Blue 8-Yellow
DATA 0 RX (COM) LED
13
Ground Wire
g R
J2
Fig. 8
Copyright © 2018 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
P5
ElectroLynx
Door
Harness
P4
P3
Fig. 7
From Reader
Board P5 to J5
J1
From Lock
Body P3 to J3