Assa Abloy Corbin Russwin ED5200N S Series Installation Instructions Manual page 12

Exit devices

Hide thumbs Also See for Corbin Russwin ED5200N S Series:

Table of Contents

ED5000N (S)(A) Series Exit Device

Install Outside Reader and Inside Mounting Plate.

If this installation involves a surface vertical rod, go to the Surface Vertical Rod sectoin on page 12.

a. Feed Reader wire harness through door and through hole in mounting plate (Fig. 6a).

b. Insert two #8 x 1-3/4" flat head through mounting plate and into escutcheon (Fig. 6a and 6b).

c. Connnect pin 5 green/yellow ground wire ring terminal to top right screw (Fig. 6b and 6c).

Note: Be careful not to pinch wires under mounting plate.

d. Check that Reader is straight on door then tighten screws.

e. Drill two 1/8" diameter holes and install (2) #8 x ¾" combination screws through plate

and into face of door.

Fig. 6a

7) Installation Instructions (Continued)

Fig. 6b

Reproduction in whole or in part without the express written

Fig. 6c Detail

permission of Corbin Russwin, Inc. is prohibited.

Table of Contents

Corbin russwin ed5200n a series