Surface Vertical Rod Installation Instructions - Assa Abloy Corbin Russwin ED5200N S Series Installation Instructions Manual

ED5000N (S)(A) Series Exit Device
1. Install Inside Mounting Bracket with Outside Escutcheon.
If this is a Surface Vertical Rod installation, follow the installation instructions on pages 4 - 8 before continuing:
a. Position outside escutcheon against door (Fig. 4A).
Note: Insert gasket, if necessary.
b. Route antenna cable through door.
c. Route wires along the outside (not through) the mounting bracket (Fig. 4B).
d. Secure with mounting bracket screws.
Ouside Escutcheon
2. Attach Ground Ring Terminal
Attach ground ring terminal to screw on bracket.
(2) Mounting
Plate Screws

8) Surface Vertical Rod Installation Instructions

Gasket
a
Fig. 1
Mounting Bracket
Mounting Plate
Mounting Bracket
d
c
b
Fig. 2
14
Copyright © 2018 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.