Table of Contents
Advertisement
Epica DG HD-SDI Boards
Specifications Epica DG HD-SDI
Applies to DG HD-SDI input board FG1055-434 and output board FG1055-437.
Important: If all of the source device EDIDs do not fall within the default resolution parameters
provided below, see "Appendix A – EDID Programmer" on page 61.
Epica DG HD-SDI Specifications
Parameter
Standard
Bit Rates
Data Type
Input Level (max.)
Input Impedance
Output Level (max.)
Output Impedance
Jitter
Rise and Fall Time
Rise and Fall Overshoot
Auto Cable Equalization
Auto Data Rate Lock
CDR (Reclocking)
Connector Type
Resolutions Supported
SMPTE 259M-C
Resolutions Supported
SMPTE 292M
Specifications Notes:
AMX reserves the right to modify its products and their specifications without notice.
58
SMPTE 292M (HD-SDI standard), SMPTE 259M-C (SD-SDI standard)
270 Mbps, 1.485 Gbps
8 bit or 10 bit
0.8 Vpp, ±10%
75 ohms
0.8 Vpp, ±10%
75 ohms
<0.2 UI
<750 ps, ±100 ps (20% to 80%)
<10%
Up to 1312 ft. (400 m) of Belden 1694A or equivalent @ 270 Mbps
Up to 919 ft. (280 m) of Belden 8281 or equivalent @ 270 Mbps
Up to 656 ft. (200 m) of Belden 1694A or equivalent @ 1.485 Gbps
Up to 328 ft. (100 m) of Belden 8281 or equivalent @ 1.485 Gbps
Yes
Yes
BNC
480i (525) @ 59.94 Hz
576i (625) @ 50 Hz
720p @ 60 Hz, 59.94 Hz, 50 Hz, 30 Hz, 29.97 Hz, 25 Hz, 24 Hz, 23.98 Hz
1080i @ 60 Hz, 59.94 Hz, 50 Hz
1080p @ 30 Hz, 29.97 Hz, 25 Hz, 24 Hz, 23.98 Hz
1080PsF @ 24 Hz, 23.98 Hz
The passing of ancillary data, including audio, is not supported.
SMPTE 259M-C or SMPTE 292M compliant timing must be provided by the source video
equipment when performing signal format conversion from DVI or RGBHV to SDI.
When utilizing signal format conversion to SDI in an Epica DG system, DVI is the preferred
source signal type. You must use the correct timing pertaining to the SMPTE standards listed
above. AMX AutoPatch provides an EDID Library with detailed timings that match the
SMPTE standards. The EDID Library also provides preset files to use to configure the
RGBHV board inputs (using the DG_HD15 Wizard) when routing signals to SDI outputs.
These files are available at www.amx.com.
Value
Epica DG Instruction Manual
Advertisement
Table of Contents
