Table of Contents
Advertisement
Attaching Inputs & Outputs
Input and output connectors are the attachment points for source and destination devices that connect to
the system. Epica DG enclosures have 18 vertical board slots (9 slots each for the input and the output
boards with up to 16 channels per board), allowing for a maximum configuration of 144x144. Viewed
from the rear of the enclosure, the input boards (for attaching sources) are on the left, and the output
boards (for attaching destinations) are on the right.
Connectors & I/O Channels
FIG. 15
Numbers indicate I/O channels
For board connector information and specifications, see the specific board chapter in this manual.
Epica DG Instruction Manual
Some Epica DG board types, their connector types, and the number of
available I/O channels per board are listed in the table below.
Board/Signal Type
# & Type of Connectors
8 DVI-I
DVI / DVI-D
4 DMS-59*
HD-SDI
16 BNC
Fiber & DVI / DVI-D
5 MTP
1 DVI-I
RGBHV
16 HD-15
* DMS-59 connectors are numbered for two breakout I/O channels each.
** MTP/MPO connectors are numbered for three I/O channels each.
Because some connectors are capable of routing multiple I/O channels, the
I/O channels are numbered rather than the connectors. The I/O channel
numbers are to the left of the connectors and read from top to bottom.
Numbering is consecutive for inputs; outputs start over at 1 and follow the
same pattern. Boards are allocated 16 I/O channels each.
Installation & Setup
# I/O Channels
®
/MPO**
8
8
16
15
1
16
33
Advertisement
Table of Contents
