Table of Contents
Advertisement
Epica DG RGBHV/HD-15 Boards
Specifications Epica DG RGBHV/HD-15
Applies to input board FG1055-422 and output board FG1055-425.
Epica DG RGBHV/HD15 Specifications
Parameter
Resolution Support
DDC/EDID Support
(EDID resolutions
provided by the Epica DG)
RGB Input Signal Level Range
RGB Input Impedance
RGB Input Coupling
RGB Output Signal Level Range
RGB Output Impedance
RGB Output Coupling
Sync Input Signal Level Range
Sync Input Impedance
Sync Output Signal Level Range
Sync Output Impedance
Connector Type
* Uses reduced sync blanking.
AMX reserves the right to modify its products and their specifications without notice.
Attaching Cables
When attaching HD-15 input and output cables, refer to the sheet labeled "AutoPatch Epica DG
Connector Guide" included with each shipment. The sheet shows where to attach each cable on the rear
of each enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet.
Caution: To avoid damage (and for service), we recommend using lacer bars or some other
type of cable management system with input and output cables.
50
Value
Up to 1920x1200 @ 60 Hz refresh rate*
1920x1200*
1920x1080*
1680x1050
1600x1200
1280x1024
1280x768
1280x720
1152x864
1024x768
800x600
640x480
0 to 750 mVpp
75 ohms
AC
0 to 750 mVpp
75 ohms
DC
0 to 5 V
510 ohms
0 to 5 V
50 ohms
HD-15
Epica DG Instruction Manual
Advertisement
Table of Contents
