Epica Dg Hd-Sdi Boards - AMX Epica DG Instruction Manual

Epica DG HD-SDI Boards

Applicability Notice
This chapter pertains to the following Epica DG (Digital Generation) HD-SDI boards:
FIG. 31 Epica DG HD-SDI boards
Epica DG enclosures are built to hold up to eighteen DG HD-SDI boards with sixteen BNC connectors
each. Each enclosure holds a maximum of nine input and nine output boards, accommodating connector
configurations up to a maximum of 144x144, as well as subsets (for example, 128x64 or 80x112).
DG HD-SDI boards can be used to route HD-SDI signals or SD-SDI signals (see supported resolutions
on page 58). DG HD-SDI input boards can also route signals to other types of Epica DG output boards,
and DG HD-SDI output boards can accept signals from other types of Epica DG input boards. When
routing signals between different board types, the Epica DG automatically converts the signal format to
match the output board.
Important: When switching an input board other than an HD-SDI input board to an HD-SDI
output board, the resolution switched to the output needs to be one of the supported
resolutions listed in the HD-SDI board specifications (see page 58).
EDID Programmer software is included on the AMX AutoPatch CD (also at www.amx.com) for
programming the input boards if necessary (see "Appendix A – EDID Programmer" on page 61).
Epica DG Instruction Manual
FG1055-434 Input board
FG1055-437 Output board
Epica DG HD-SDI Boards
57