Appendix D - Programmer's Interface For System Diagnostics; System Component Information - AMX Epica DG Instruction Manual

Appendix D – Programmer's Interface
for System Diagnostics

System Component Information

The Epica DG displays system information in its splash screen* for diagnostic purposes. The
information indicates the current status and well-being of the system components.
~scr!
[1:Enclosure] AutoPatch Epica DG
[2:Storage Blocks] cleared
[3:Communication Interfaces] count = 3
[4:Hardware Boards] detected
[5:VM Configuration] count = 1
[6:Power System] good
[7:System Sensors] detected
Example of a default Epica DG splash screen
FIG. 37
The splash screen can be accessed using a terminal emulation program, such as HyperTerminal
(see page 36). One of four verbosity** settings is specified to provide a level of detail for information on
seven system components. Only one verbosity setting and one component setting can be entered in a
command. The order in which these two settings are entered is interchangeable.
Note: In a multi-enclosure system, the splash screen displays information only for the enclosure that
is connected directly to the PC.
* AMX reserves the right to add to the contents of the splash screen at any time, without notice.
** Verbosity (i.e., wordiness) refers to the amount of information provided; the higher the verbosity
setting, the more information is displayed.
Epica DG Instruction Manual
Appendix D – Programmer's Interface for System Diagnostics
Command entered to display minimal information
for all system components
The system components' identity numbers are
to the left of each component
91